SKU: IGO-N502HJ-01

At-home gonorrhea test – swab, for women and men, JusChek 1 test

JusChek rapid cassette test for the qualitative detection of Neisseria gonorrhoeae antigens — the bacterium that causes gonorrhea, one of the most common bacterial sexually transmitted infections. For women and men, result in 10 minutes.

29 PLN / pcs. In stock

Product details

Purpose
Rapid self-test for the qualitative detection of Neisseria gonorrhoeae (gonorrhoea) antigens in a cervical swab (women) or a urethral swab (men). Aids in the diagnosis of gonorrhoea infection. In vitro diagnostic medical device.
Result time
10 minutes
Sample type
Cervical or urethral swab
Sensitivity
96.0%
Specificity
98.3%
Certificates
CE 3018
Storage
Temperature: 2–30°C. Do not freeze. Store in a dry place out of the reach of children. Do not swallow the buffers.
Preparation
Women: do not collect the swab during menstruation – excess blood on the swab may give a false positive result. Men: do not urinate for at least one hour before collecting the swab. The test and buffers should be at room temperature (15–30 °C). Wash your hands with soap and rinse them with clean water. Have a timer ready. Just before collecting the swab, remove the cap from the buffer 1 tube (colourless liquid) and place the tube in the holder on the box – the sample must be tested immediately.
Procedure
1. Collect the swab. Women: take out the sterile cervical swab, insert its tip into the vagina, rotate it firmly 360° in one direction, wait 15 seconds and remove it carefully, avoiding contact with other surfaces. Men: take out the sterile urethral swab, insert its tip about 2–4 cm into the urethra, rotate it 360° in one direction, wait 10 seconds and remove it carefully. 2. Immediately put the swab into the buffer 1 tube, squeeze the bottom of the tube and rotate the swab 15 times. Wait 2 minutes. 3. Snap off the tip of the buffer 2 ampoule (yellow liquid) at its narrowest point and pour all of the solution into the tube. The solution will turn cloudy – this is normal. 4. While squeezing the tube, rotate the swab 15 times until the solution becomes clear with a slight greenish or bluish tint. Wait 1 minute. 5. Press the swab against the wall of the tube and remove it while squeezing the tube, so that as much liquid as possible stays inside. Close the tube with the cap, then open the small cap at its tip. 6. Take the test cassette out of the foil pouch and place it on a clean, flat surface. Use it within one hour. 7. Turn the tube upside down and add 3 full drops of the solution to the sample well (S). Start the timer. Avoid air bubbles and do not move the cassette. 8. Read the result after 10 minutes. Do not interpret the result after 30 minutes.
Result interpretation
Positive: two coloured lines are visible – control (C) and test (T). Any visible T line, even a faint one, means a positive result – contact a doctor promptly and show them the result. Negative: only the control line (C) is visible – gonorrhoea antigens were not detected or are below the detection limit of the test; if symptoms persist or get worse, consult a doctor. Invalid: no control line (C) – repeat the test with a new kit. The test cannot be used to assess the success of treatment.
Kit contents
1 test cassette, 1 sterile cervical swab (for women), 1 sterile urethral swab (for men), buffer 1 (0.3 ml), buffer 2 (0.24 ml), package insert. The tube holder is on the box. A timer is needed (not included).
Manufacturer
Hangzhou Alltest Biotech Co., Ltd.
EU authorized representative
MedNet EC-REP GmbH, Borkstrasse 10, 48163 Münster, Germany
EAN
6942598249062